본문
There may be differences in using photos on the site.
The test pressure of high pressure joint test should remain at 5kg/㎠ or higher for 5mins and should not decrease to 4kg/㎠ or below. If it decreases below, join them again and do the hydraulic pressure test again. The test is done with extremely high pressure, so you must make sure of safety and take safety actions before, after and during use.
Control Panel
| Check Point (Pipe) Air Inspection Pressure( Pre-Pressurization Time : 5min) | |||||||||
| Low Pressure (LC) | High Pressure (LD) | ||||||||
| kpa | Mpa | Kgf/㎠ | bar | psi | kpa | Mpa | Kgf/㎠ | bar | psi |
| 9.81 | 0.01 | 0.101 | 0.1 | 1.45 | 20 | 0.02 | 0.203 | 0.20 | 2.90 |
Digital Gauge
| Part Number | Digital Gauge (Standard Pressure Spec : Max ) | ||||
| kpa | Mpa | Kgf/㎠ | bar | psi | |
| DPG3600 | 1470.09 | 1.14709 | 14.71 | 15.0 | 213.36 |
Plugs
| Part Number | Usage Size | Max. Air Injection Pressure |
Maximum Back Pressure |
Product Weight |
Deflated Length |
Deflated Diameter |
||||||
| Ø | inch | Kgf/㎠ | bar | Kgf/㎠ | bar | kg | lb | mm | inch | Ø | inch | |
| Air-0012 | 100-200 | 4-8 | 0.7 | 0.69 | 0.18 | 0.17 | 2 | 4.40 | 540 | 21.6 | 88 | 3.5 |
| Air-0013 | 150-300 | 6-12 | 0.7 | 0.69 | 0.18 | 0.17 | 3 | 6.61 | 640 | 25.6 | 140 | 5.6 |
| Air-0014 | 200-500 | 8-20 | 0.7 | 0.69 | 0.18 | 0.17 | 9 | 19.8 | 870 | 34.8 | 180 | 7.2 |
| Air-0015 | 300-600 | 12-24 | 0.7 | 0.69 | 0.20 | 0.19 | 16 | 35.2 | 980 | 38.5 | 280 | 11.2 |
| Air-0016 | 450-1000 | 18-40 | 0.7 | 0.69 | 0.20 | 0.19 | 39 | 85.9 | 1300 | 56.1 | 440 | 17.6 |
| Air-0017 | 600-1200 | 24-48 | 0.7 | 0.69 | 0.20 | 0.19 | 62 | 136.6 | 1700 | 68 | 500 | 20.0 |
Air Hose
| Color | Purpose | Size | Coupler | Note |
| Red | Plug In | Ø12 X 10m | 6A (1/8) | |
| PVC Transparent Hosiery Yarn Spiral Hose |
Check Point In | Ø20 X 10m | 20A (3/4) | Kamlok Coupler |
Use of Product : For pneumatic pressure test
